Connecting and disconnecting a trailer
Stop your vehicle and a trailer in line and perform the following:
• Connecting a trailer
Set the rear height control air
suspension to N mode.
Turn off the “ENGINE START STOP”
switch or the rear height control air suspension.
Connect the trailer.
Turn on the switch that was turned
off on 
.
• Disconnecting a trailer
Set the rear height control air
suspension to N mode.
Turn off the rear height control
air suspension.
Turn off the “ENGINE START STOP”
switch.
Set the supporting leg of the trailer
on the ground and raise the hitch by 4 in. (100 mm)
Turn on the “ENGINE START STOP” switch.
Turn on the rear height control
air suspension.
Wait until vehicle height is stabilized.
Make sure the hitch is disconnected. If the hitch does not disconnect, raise the hitch higher and repeat steps 2 through 7.
See also:
Tire information
Typical tire symbols
1 Tire size
2 Summer tire or all season tire
An all season tire has “M+S” on the sidewall. A tire not marked
“M+S” is a summer tire.
3 Uniform tire quality grading
...
Power steering fluid
- Fluid level
The fluid level should be within the appropriate range.
1. Full (when cold)
2. Add fluid (when cold)
3. Full (when hot)
4. Add fluid (when hot)
Hot: The vehicles has been d ...
Glove box
1 Open (push button)
2 Unlock with the mechanical
key
3 Lock with the mechanical
key
- Glove box light
The glove box light turns on when the tail lights are on.
- Removing the separate tray ...