Cooling system

Ignition system

    See also:

    Security and system setup
     - Security setting items and operation procedures To enter the menu for each function, follow the steps below using a voice command or the “TUNE/SEL” knob: • Setting or changing the PI ...

    Checking and replacing fuses
    If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Turn the “ENGINE START STOP” switch off. Open the fuse ...

    Follow the correction procedures.
    A buzzer sounds and a warning message is shown on the multi-informa- tion display. After taking the specified steps to correct the suspected problem, check that the warning message goes off. ...