Destination search by “Coordinates”
1. Push the “DEST” button.
2. Touch “Coordinates” on the second page of the “Destination” screen.
3. Input the latitude and the longitude.
4. When the input is finished, touch “OK”.
By touching the button of the desired point, the screen changes and displays the map location of the selected destination and the route preference. (See “Starting route guidance” on page 83.)
See also:
Follow the correction procedures.
A buzzer sounds and a warning message is shown on the multi-informa- tion display.
After taking the specified steps to correct the suspected problem, check that the
warning message goes off.
...
Display
When the sensors detect an obstacle, a graphic is shown on the multi- information
display depending on the position and distance to the obsta- cle.
Optitron meter
1. Front corner sensor operatio ...
When the VSC/TRAC or Active TRAC/hill-start assist control systems are operating
If the vehicle is in danger of slip- ping or rolling backward when starting on
an incline, or if any of the drive wheels spins, the slip indi- cator light flashes
to indicate that the VSC/TRAC or ...