Locking the driver’s door from the outside without a key
Move the inside lock button to the
lock position.
Close the door.
The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode, or the electronic key is left inside the vehicle.
The key may not be detected correctly and the door may be locked.
See also:
Setting route
DETOUR SETTING
While the route guidance is operating,
the route can be changed to detour
around a section of the route where a
delay is caused by road repairs, or an ac-
cident, etc.
1 Touch “ ...
When the VSC/TRAC or Active TRAC/hill-start assist control systems are operating
If the vehicle is in danger of slip- ping or rolling backward when starting on
an incline, or if any of the drive wheels spins, the slip indi- cator light flashes
to indicate that the VSC/TRAC or ...
Changing the registered name in the phone book
Select “Change Name” using a voice
command or the “TUNE/ SEL” knob.
Pattern A
Select the name to be changed by
either of the following meth- ods, and select “Confirm” using a voice ...