Setting up the display
Setting up the information display
To set up the display, press the “DISP” switch until the desired item appears.
If left idle for approximately 10 seconds, the display will revert to the previous screen.
Setting the contrast
Press the display adjustment switch (“∧” or “∨”) to adjust the contrast.
+: Strengthen
-: Weaken
Setting the brightness
Press the display adjustment switch (“∧” or “∨”) to adjust the brightness.
+: Brighter
-: Darker
Setting the day mode
Press the display adjustment switch (“∧” or “∨”) to select ON or OFF.
Setting up the display of the monitors
Press the display adjustment switch (“∧” or “∨”) to adjust the contrast.
+: Strengthen
-: Weaken
Setting the brightness
Press the display adjustment switch (“∧” or “∨”) to adjust the brightness.
+: Brighter
-: Darker
Liquid crystal display
Small spots or light spots may appear on the display. This phenomenon is character- istic of liquid crystal displays, and there is no problem continuing to use the display.
Outside temperature display
In the following situations, the correct outside temperature may not be displayed, or the display may take longer than normal to change.
• When stopped, or driving at low speeds (less than 12 mph [20 km/h])
• When the outside temperature has changed suddenly (at the entrance/exit of a garage, tunnel, etc.)
When “--” or “E” is displayed on the outside temperature display
The system may be malfunctioning. Take your vehicle to your Lexus dealer.
When disconnecting and reconnecting battery terminals
The following information data and settings will be reset:
• Average fuel consumption after refueling
• Average fuel consumption
• Average vehicle speed
• Elapsed time
Customization
Setting of available languages can be changed.
NOTICE
The multi-information display at low temperatures
Allow the interior of the vehicle to warm up before using the liquid crystal informa- tion display. At extremely low temperatures, the information display monitor may respond slowly, and display changes may be delayed.
See also:
Stowing the flat/spare tire, jack and tools
Lay down the tire with the outer side facing up, and install the hold- ing bracket.
Insert the holding bracket tab into one of the holes in the wheel.
Raise the tire.
Pull the tire towards the re ...
Approach warning
When your vehicle is too close to a vehicle ahead, and sufficient auto- matic
deceleration via the cruise control is not possible, the display will flash and
the buzzer will sound to alert the dri ...
Hitch
Trailer hitch assemblies have different weight capacities. Lexus recom- mends
the use of Lexus hitch/bracket for your vehicle. For details, con- tact your Lexus
dealer.
• If you wish to install ...