Initial screen

When the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode, the initial screen will be displayed and the system will begin operating.
CAUTION
When the vehicle is stopped with the engine running, always apply the parking brake for safety.

screen automatically switches to the map screen. When touching “Show Map” or pushing the “MAP/VOICE” button, the map screen is displayed.
While the “CAUTION” screen is displayed, the “DEST” or “SETUP” button cannot be operated. And if the “Calendar” button on the “Information” screen is touched, the screen will change back to the “CAUTION” screen. In about 5 seconds, or when the “MAP/VOICE” button is pushed or the “Show Map” is touched, the “CAUTION” screen will change to the map screen.
Maintenance information
This system informs about when to replace certain parts or components and shows dealer information (if registered) on the screen.
When the vehicle reaches a previously set driving distance or date specified for a scheduled maintenance check, the “Information” screen will be displayed when the navigation system is in operation.

To disable this screen, touch “Do Not Display This Message Again”. This screen goes off if the screen is not operated for several seconds. To prevent this information screen from being displayed again, touch “Do Not Display This Message Again”.
To register “Maintenance information”, see “—Maintenance” .
See also:
Setting up the “Address Book”
Points or areas on the map can be registered.
1. Push the “SETUP” button.
2. Touch “Navi.” on the “Setup” screen.
3. Touch “Address Book”.
- Registering address book entr ...
Body Repairs
If you’re involved in a collision, you
want your vehicle to be returned to
its pre-accident condition when
repaired. That’s why it is important to
make sure repairs are made only with
Genuine ...
DAC (Downhill Assist Control system)
The DAC helps to prevent excessive speed on steep downhill slopes.
The system will operate when the vehicle is traveling under 15 mph (25 km/h)
and the four-wheel drive control switch is in the L4 ...
