Intuitive parking assist setting
The volume of the beeps and turning on or off of the display can be set.
1. Push the “SETUP” button.
2. Touch “Vehicle” on the “Setup” screen.
3. Touch “LEXUS Park Assist”.
4. Touch the desired button.
5. Touch “Save”.
Setting an alert volume
The alert volume can be adjusted. 1. Push the “SETUP” button.
2. Touch “Vehicle” on the “Setup” screen.
3. Touch “LEXUS Park Assist” on the “Vehicle Settings” screen.
4. Touch the desired button. The volume has 5 levels, increasing with higher value or decreasing with lower value.
5. Touch “Save”.
Setting a parking sonar display
“On” or “Off” can be selected for parking sonar display. 1. Push the “SETUP” button.
2. Touch “Vehicle” on the “Setup” screen.
3. Touch “LEXUS Park Assist” on the “Vehicle Settings” screen.
4. Touch the desired button.
5. Touch “Save”.
Although “Off” is selected, if the obstacle is detected while using rear view monitor system or wide view front & side monitor, the warning appears on the screen.
Setting a display and tone indication
Front and back sensors display and tone indication can be set. 1. Push the “SETUP” button.
2. Touch “Vehicle” on the “Setup” screen.
3. Touch “LEXUS Park Assist” on the “Vehicle Settings” screen.
4. Touch “Front” or “Rear”.
Selecting “Front” or “Rear” to switch the distance for the front or back sensors display and tone indication, from long distance to short distance, or from short distance to long distance.
5. Touch “Save”.
See also:
Using the AUX port
This port can be used to connect a portable audio device and listen to it
through the vehicle’s speakers.
Slide the auxiliary box lid.
Open the cover and connect the portable audio device.
...
Setting up the “Address Book”
Points or areas on the map can be registered.
1. Push the “SETUP” button.
2. Touch “Navi.” on the “Setup” screen.
3. Touch “Address Book”.
- Registering address book entr ...
Changing the passkey
Select “Set Passkey” using a voice
command or the “TUNE/SEL” knob.
Pattern A
Press the talk switch, say a 4 to
8-digit number, and select “Con- firm” using a voice command or the ...