Replacing a flat tire
Chock the tires.
Pry off the wheel ornament, using the beveled end of the wheel orna- ment remover as shown.
Slightly loosen the wheel nuts (one turn).
Assembling the jack handle.
Remove the jack handle, jack handle extension bar and jack han- dle bar from the tool box and assemble by following these steps.
1. Loosen the bolt and the screw using either the jack handle end or a screwdriver.
2. Assemble the jack handle extension bar and the jack han- dle bar and tighten the bolts.
Check that the bolts are firmly tightened.
3. Assemble the jack handle extension bar and the jack han- dle and tighten the screw.
Check that the screw is firmly tight- ened.
Position the jack at the jack points as shown.
Front - Under the chassis frame side rail
Rear - Under the rear axle housing
Raise the vehicle until the tire is slightly raised off the ground.
Remove all the wheel nuts and the tire.
When resting the tire on the ground, place the tire so that the wheel design faces up to avoid scratching the wheel surface.
See also:
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt, or snow:
Stop the engine. Set the parking
brake and shift the shift lever to P.
Remove the mud, ...
Disabling pre-collision braking
1.Pre-collision braking disabled
2.Pre-collision braking enabled
The “PCS” warning light turns on when pre-collision braking is dis- abled. ...
Destination search by “Address”
There are 2 ways to search a destination by address.
(a) Search by city
(b) Search by street address
1. Push the “DEST” button.
2. Touch “Address” on the “Destination” screen.
3. To ...