Details
You can do the detail settings.
1. Push the “SETUP” button.
2. Touch “Phone”.
3. Touch “Details”.
4. Do each setting according to the following procedures.
5. When you complete each setting, touch “Save”.
Incoming call display
You can select the method of the incoming call display.
1. Touch “Incoming Call Display Mode”.
2. Touch “Full Screen” or “Drop Down”.
“Full Screen” mode
When a call is received, the Hands−free screen is displayed and you can operate it on the screen.
“Drop Down” mode
The message is displayed on the upper side of the screen.
You can only operate the steering switch.
The Bluetooth connection status at start up
When the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode and the Bluetooth is automatically connected, the connection check is displayed.
When “Display Phone Status” is “On”, this status is displayed.
When “Display Phone Status” is “Off”, this status is not displayed.
1. Touch “Display Phone Status”.
2. Touch “On” or “Off”.
Initializing the settings
You can initialize the settings.
1. Touch “Default”.
2. Touch “Yes”.
See also:
When receiving a phone call
- Answering the phone
Press the off-hook switch.
- Refusing the call
Press the on-hook switch. ...
Menu list of the Bluetooth® audio system
- Normal operation
- When using a voice command
For numbers, say a combination of single digits from zero to nine.
Say the command correctly and clearly
- Situations that the s ...
Moon roof
Use the overhead switches to open and close the moon roof and tilt it up and
down.
Opening and closing
1. Opens the moon roof*
The moon roof stops slightly before the fully open position to red ...