Distance and time to destination

When the vehicle is on the guidance route, the distance and the estimated travel/arrival

When the vehicle is on the guidance route, the distance and the estimated travel/arrival time to the destination are displayed.

When the vehicle is not on the guidance route, the distance and the direction of the destination are displayed.

When driving on the guidance route and more than one destination is set, the distance and the estimated travel/arrival time from the current position to each destination are displayed.

1. Touch this button to display the following screen.

2. Touch the number button to display the desired destination.

2. Touch the number button to display the desired destination.

The distance, the estimated travel time and the estimated arrival time from the current position to the selected destination are displayed.

Estimated arrival time is displayed. Estimated travel time is displayed.

To switch to estimated arrival Estimated arrival time is displayed.

time. To switch to estimated arrival time.

time. To switch to estimated travel time.

guidance route. The destination direction is indicated by an arrow. Displayed while driving off the guidance route. The destination direction is indicated by an arrow.

INFORMATION

When the vehicle is on the guidance route, the distance measured along the route is displayed. Travel time and arrival time is calculated based on the set vehicle speed information.

 However, when the vehicle is not on the guidance route, the distance is the linear distance between the current position and the destination.

    See also:

    Specifications
    Maintenance data (fuel, oil level, etc.) Dimensions and weight *1: Unladen vehicles. *2: Vehicles without roof antenna and roof rails. *3: Vehicles with roof antenna but without electronically m ...

    Four-wheel drive system
    Use the four-wheel drive control switch and center differential lock/unlock switch to select the following transfer and center differential modes. Four-wheel drive control switch 1.  H4 (hi ...

    Stowing the flat/spare tire, jack and tools
    Lay down the tire with the outer side facing up, and install the hold- ing bracket. Insert the holding bracket tab into one of the holes in the wheel. Raise the tire. Pull the tire towards the re ...