The system sounds the alarm and flashes lights when forcible entry is detected.

- Triggering of the alarm
The alarm is triggered in the following situations when the alarm is set: l A locked door is unlocked or opened in any way other than by using the entry function or the wireless remote control.

(The doors will lock again automatically.)
l The hood is opened.
l The battery is reconnected.

- Setting the alarm system

Close the doors and hood,

Close the doors and hood, and lock all doors.

The system will be set automatically after 30 seconds.

The indicator light changes from being on to flashing when the system is set.

- Deactivating or stopping the alarm
Do one of the following to deactivate or stop the alarm.

l Unlock the doors.
l Turn the “ENGINE START STOP” switch to ACCESSORY or IGNITION ON mode, or start the engine. (The alarm will be deactivated or stopped after a few seconds.)

- System maintenance
The vehicle has a maintenance-free type alarm system.

- Items to check before locking the vehicle
To prevent unexpected triggering of the alarm and vehicle theft, make sure of the following.

l Nobody is in the vehicle.
l The windows and moon roof are closed before the alarm is set.
l No valuables or other personal items are left in the vehicle.

- Triggering of the alarm
The alarm may be triggered in the following situations. (Stopping the alarm deactivates the alarm system.)

l A person inside the vehicle opens a

l A person inside the vehicle opens a door or hood.

l The battery is reconnected.

l The battery is reconnected.

- When the battery is disconnected
Be sure to cancel the alarm system.

If the battery is disconnected before canceling the alarm, the system may be triggered when the battery is reconnected.

- Alarm-operated door lock
l When the alarm is operating, the doors are locked automatically to prevent intruders.
l Do not leave the key inside the vehicle when the alarm is operating, and make sure the key is not inside the vehicle when recharging or replacing the battery.

- Panic mode

When  is pressed for longer than

When about one second, the head lights/tail is pressed for longer than about one second, the head lights/tail lights/emergency flashers will flash, the front and rear interior lights will come on, and an alarm will sound for about 60 seconds to deter any person from trying to break into or damage your vehicle.

To stop the alarm, press any button on the wireless remote control.


- To ensure the system operates correctly
Do not modify or remove the system. If modified or removed, the proper operation of the system cannot be guaranteed.

    See also:

    Rear differential
    *: Your Lexus vehicle is filled with “Toyota Genuine Differential Gear Oil” at the factory. Use Lexus approved “Toyota Genuine Differential Gear Oil” or an equivalent of matching qualit ...

    Follow the correction procedures.
    A buzzer sounds and a warning message is shown on the multi-informa- tion display. After taking the specified steps to correct the suspected problem, check that the warning message goes off. ...

    If the electronic key does not operate properly
    ■Unlocking and locking the doors To unlock or lock the vehicle, use the mechanical key. The mechanical key is stored inside the electronic key. 1 Unlocks 2 Locks ■Starting the en ...