Installing the spare tire
Remove any dirt or foreign matter from the wheel contact surface.
If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, and the tire may come off the vehicle.
Install the spare tire and loosely tighten each nut by hand to approximately the same amount.
Turn the lug nuts until the washers come into contact with the disc wheel.
Lower the vehicle.
Firmly tighten each nut two or three times in the order shown in the illustration.
Tightening torque:
83 ft•lbf (112 N•m, 11.4 kgf•m)
Reinstall the wheel ornament
See also:
Crawl Control (with Turn Assist function)
Crawl Control allows travel on extremely rough off-road surfaces at a fixed
low speed without
pressing the accelerator or brake pedal.
To select a speed mode, shift the Crawl Control
switch for ...
Cargo and luggage
Take notice of the following information about storage precautions, cargo
capacity and load:
• Stow cargo and luggage in the luggage compartment whenever possible.
• Be sure all items are secu ...
Set up screen
You can change the touch screen to your desired settings.
Press the “SETUP” button to display the “Setup” screen.
General settings
This screen is used for language selection and the o ...