Steps to take in an emergency
- If a warning light turns on or a warning buzzer sounds...
- If a warning message is displayed
- If you have a flat tire
- If the engine will not start
- If the shift lever cannot be shifted from P
- If you lose your keys
- If the electronic key does not operate properly
- If the vehicle battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
- If your vehicle has to be stopped in an emergency
See also:
Setting speed dials
Select “Set Speed Dial (Speed Dial)”
using a voice command or the “TUNE/SEL” knob.
Pattern A
Select the data to be registered
as a speed dial by either of the following methods, and se ...
Disabling pre-collision braking
1.Pre-collision braking disabled
2.Pre-collision braking enabled
The “PCS” warning light turns on when pre-collision braking is dis- abled. ...
Distance and time to destination
When the vehicle is on the guidance route, the distance and the estimated travel/arrival
time to the destination are displayed.
When the vehicle is not on the guidance route, the distance and the ...
