Selecting a cellular phone to be used
Select “Connect Phone (Connect)”
using a voice command or the “TUNE/SEL” knob.
Pattern A
Select the cellular phone to be
used by either of the following methods, and select “Confirm” by using a voice command
or the “TUNE/SEL” knob:
a. Press the talk switch and say the name of the desired cellular phone.
b. Press the talk switch and say “List Phones”. When the name of the desired cellular phone is read aloud, press the talk switch.
Pattern B
Select the cellular phone to be
used using the “TUNE/SEL” knob.
See also:
Stowing the flat/spare tire, jack and tools
Lay down the tire with the outer side facing up, and install the hold- ing bracket.
Insert the holding bracket tab into one of the holes in the wheel.
Raise the tire.
Pull the tire towards the re ...
Disabling the height control
When the height control OFF switch is pressed with the vehicle stopped, the vehicle
height is fixed at the current height.
This status is memorized in the sys- tem even after the engine is stoppe ...
Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles up to approximately
400 ft. (120 m) ahead, determines the current vehicle- to-vehicle following distance,
and operates to mainta ...