The voice command system enables you to operate the navigation system, audio/ video system, air conditioning system and

hands−free system by giving a command.

1. Push the talk switch.

After a beep sounds, the “Voice Menu” screen is displayed.

INFORMATION

Voice guidance for the voice command system can be skipped by pushing the talk switch.

The voice recognition prompt can be set to on or off when “Voice Prompts (on/off)” is touched.

This setting can also be changed on the “Voice Settings” screen.

When “Voice Prompts (on/off)” is touched, voice recognition will be temporarily suspended.

Push the talk switch again.

Voice guidance can be canceled by setting voice prompts to off.

Use this setting when you want to say a command immediately after pushing the talk switch.

2. After a beep sounds, say the command of your choice.

Voice commands are marked with .

Some commonly used commands are displayed on the screen. Speak the commands as displayed on the screen.

If you want to check the all command list, say “Command list” to display the command list screen.

3. Following voice guidance, say the command displayed on the screen.

If a desired outcome is not shown, or if no choices are available, say “Go back” or touch “Go Back” to return to the previous screen.

To cancel voice command recognition, say “Cancel”, touch “Cancel”, or push and hold the talk switch.

If the navigation system does not respond or the confirmation screen does not disappear, please push the talk switch and try again.

If a voice command cannot be recognized within 6 seconds, the voice guidance system will say “Pardon?” (“Command not recognized.” will be displayed on the screen) and voice command reception will restart.

If a voice command cannot be recognized two consecutive times, the voice guidance system will say “Paused. To restart voice recognition, push the talk switch.”, then be suspended.

Microphone

It is unnecessary to speak directly into the microphone when giving a command.

INFORMATION

Wait for the confirmation beep before speaking a command.

Voice commands may not be recognized if :

Spoken too quickly

Spoken at a low or high volume

The windows or moon roof are open

Passengers are talking while voice commands are spoken

The air conditioning speed is set high

Turning the air conditioning vents towards the microphone

In the following conditions, the system may not recognize the command properly and using voice commands may not be possible.

The command is not correct or clear.

Note that certain words, accents, or speech patterns may be difficult for the system to recognize.

There are some noises such as wind noise, etc.

Voice command example: Searching for a route to your home.

1. Push the talk switch.

2. Say “Go home”.

If a home address is not registered, the voice guidance system will say “Your home is not set” and you will be prompted to enter a home address. When the voice command is recognized, a map of the area around your home is displayed.

3. Touch “Enter” or say “Enter”, and the system starts searching for a route to your home.

To return to the “Voice Menu” screen, say “Go back” or touch “Go Back”. Touch “Cancel” or say “Cancel”, and the voice command system will be canceled.