Using the video mode
Push “VIDEO” to select the video mode.
Before switching to the video mode, connect the audio−video equipment to the A/V input port.
When “Speaker Output” is off, any audio− video source can be selected for the other rear display. See “ Changing the speaker output” on page 268.
Using the port
Push and release the lid.
The A/V input port is composed of 3 input ports.
Yellow: Image input port
White: Left channel audio input port
Red: Right channel audio input port
The rear seat entertainment system plays videos and sound when audio−video equipment is connected to the A/V input port. For details, refer to the manufacturer’s instructions.
NOTICE
When the A/V input port is not in use, keep the A/V input port cover closed.
Inserting anything other than an appropriate plug may cause electrical failure or a short circuit.
If the video is not correctly displayed
Push “DISPLAY”.
Select “PAL VIDEO”.
If the video is not correctly displayed, turn “PAL VIDEO” on or off.
See also:
Initialization
Items to initialize
The following items must be initialized for normal system operation in
cases
such as after the 12-volt battery is reconnected, or maintenance is performed
on the vehicle.
...
Radio operation (XM Satellite Radio broadcast)
To listen to a satellite radio broadcast in your vehicle, a subscription to the
XM Satellite Radio service is necessary.
(a) How to subscribe to an XM Satellite Radio
An XM Satellite Radio is a tu ...
Disabling the height control
When the height control OFF switch is pressed with the vehicle stopped, the vehicle
height is fixed at the current height.
This status is memorized in the sys- tem even after the engine is stoppe ...