Cruise Control
Cruise control allows the driver to maintain a constant speed without having to operate the accelerator pedal.
Use for highway driving or when traveling at a constant speed for long periods of time.
1 Indicator
2 Cruise control switch
■Setting the vehicle speed
1 Press the “ON-OFF” button.
The system will turn on.
2 Accelerate or decelerate to the desired speed, and then push the lever down.
This sets the speed in the cruise control memory.
■Adjusting the set speed
To increase speed: push the lever up.
To decrease speed: push the lever down.
Release the lever when the desired speed is reached.
■Canceling and resuming the constant speed control
1 To temporarily cancel the constant speed control,
pull the lever toward you. To resume the
constant speed control, push the lever up.
2 To turn the system off, press the “ON-OFF”
button.
See also:
Setting route
DETOUR SETTING
While the route guidance is operating,
the route can be changed to detour
around a section of the route where a
delay is caused by road repairs, or an ac-
cident, etc.
1 Touch “ ...
Engine coolant
The coolant level is satisfactory if it is between the “F” and “L” lines on the
reservoir when the engine is cold.
1. Reservoir cap
2. Full
3. Low
If the level is on or below the “L ...
If a warning light turns oor a warning buzzer sounds
Calmly perform the following actions if any of the warning lights turn
on or flash. If a light turns on or flashes, but then turns off, this does
not necessarily indicate a malfunction in the system ...