Changing the passkey

command or the “TUNE/SEL” knob. Select “Set Passkey” using a voice command or the “TUNE/SEL” knob.

Pattern A

8-digit number, and select “Con- firm” using a voice command or the “TUNE/SEL” knob. Press the talk switch, say a 4 to 8-digit number, and select “Con- firm” using a voice command or the “TUNE/SEL” knob.

Pattern B

the “TUNE/SEL” knob. Select a 4 to 8-digit number using the “TUNE/SEL” knob.

The number should be input 1 digit at a time.

as a passkey has been input, press the “TUNE/SEL” knob again. When the entire number to be registered as a passkey has been input, press the “TUNE/SEL” knob again.

If the number to be registered has 8 digits, pressing of the knob is not necessary.

    See also:

    Console box
    Console box (if equipped) Your vehicle is equipped with either a console box or cool box. For vehicles with the cool box, refer to page 691. Lift the lid while pulling up the lower lever to re ...

    Have the malfunction repaired immediately.
    After taking the specified steps to correct the suspected problem, check that the warning message and light go off. ...

    The distance display and buzzer
    When a sensor detects an obstacle, the direction of and the approximate distance to the obstacle are displayed and the buzzer sounds. Distance display Corner sensor Center sensors Buzzer ope ...