Setting up a Bluetooth® enabled portable player
Registering a portable player in the Bluetooth® audio system allows the system to function. The following functions can be used for registered portable players:
- Functions and operation procedures
Pattern A
To enter the menu for each function, follow the steps below using a voice command or the “TUNE/SEL” knob:
• Registering a portable player
1. “Setup” → 2. “Bluetooth Audio Setup (BT•A Setup)” → 3. “Pair Audio Player (Pair Audio)”
• Selecting a portable player to be used
1. “Setup” → 2. “Bluetooth Audio Setup (BT•A Setup)” → 3. “Connect Audio Player (Connect)”
• Changing the registered name of a portable player
1. “Setup” → 2. “Bluetooth Audio Setup (BT•A Setup)” → 3. “Change Name”
• Listing the registered portable players
1. “Setup” → 2. “Bluetooth Audio Setup (BT•A Setup)” → 3. “List Audio Players (List Audios)”
• Changing the passk
1. “Setup” → 2. “Bluetooth Audio Setup (BT•A Setup)” → 3. “Set Passkey”
• Deleting a registered portable player
1. “Setup” → 2. “Bluetooth Audio Setup (BT•A Setup)” → 3. “Delete Audio Player (Delete Audio)”
Pattern B
Press the “TUNE/SEL” knob to select
“BT•A MENU”.
Press the talk switch or select
“BT•A Setup” using the “TUNE/ SEL” knob.
Select one of the following functions
using a voice command or the “TUNE/SEL” knob.
• Registering a portable player
“Pair Audio Player (Pair Audio)”
• Selecting a portable player to be used
“Connect Audio Player (Connect)”
• Changing the registered name
“Change Name”
• Listing the registered portable players
“List Audio Players (List Audios)”
• Changing the passkey
“Set Passkey”
• Deleting a registered portable player
“Delete Audio Player (Delete Audio)”
- Registering a portable player
- Selecting a portable player to be used
- Changing the registered name of a portable player
- Listing the registered portable players
- Changing the passkey
- Deleting a registered portable player
See also:
Installing the spare tire
Remove any dirt or foreign matter from the wheel contact surface.
If foreign matter is on the wheel contact surface, the wheel nuts may loosen
while the vehicle is in motion, and the tire may com ...
Erasing the entire HomeLink® memory (all three programs)
Press and hold the 2 outside but- tons for 10 seconds until the indi- cator light
flashes.
If you sell your vehicle, be sure to erase the programs stored in the HomeLink®
memory.
- Befo ...
Adjusting the position of and opening and closing the air outlets
Front center outlets
1. Direct air flow to the left or right, up or down
2. Turn the knob to open or close the vent
Front side outlets
1. Direct air flow to the left or right, up or down
2. T ...